Clamping Unit

1.Low-pressure mould protection

2.Hydraulic mould height adjustment

3.Hydraulic safety device(except PD60-PD148)

4.4-speed & 4-pressure mould open

5.4-speed & 4-pressure clamping

6.High speed regenerative mould closing circuit(except PD60-PD148)

7.Hard chrome-plated with high tensile steel tie bars

8.Energy saving pump

9.The newly designed clamping cylinder is much more stable than what it used to be which also lighten the vibration and the dash over.

10.The optimized clamping design based upon the dedicated stress analysis.

11.Regenerated hydraulic closing circuit increases the clamping speed by 60% accomplishes the Hi-speed,short cycle time and economical energy consumption.

12.5The goggle clamping can be enforced by enlarging the cross sectional area of the injection cylinder which also is featured in energy saving.

13.Pretty Hi-speed on 1st clamping stage shorten the cycle time,automatically lower the mold clamping speed before two halves touch to protect the mold being damaged.

14.The moving platen designed with slipper working on the level belt ensures the parallel precision of the moving platen as well as the stabilization of the mold clamping and lessen the wear and tear.